Differences

This shows you the differences between two versions of the page.

--- auth:howto:linux:vpnclient [2019/04/12 11:57] – [Instructions for MacOS X] kohofer
+++ auth:howto:linux:vpnclient [2020/04/21 16:56] – kohofer
@@ Line 68: / Line 68: @@
   - Enter Password if not already entered above
-===== Instructions for Linux vpnc Client (recommended) =====
+===== Instructions for Linux using openconnect Client (recommended) =====
+Run this command to install openconnect client and OpenConnect plugin GNOME GUI
+  sudo apt install openconnect network-manager-openconnect network-manager-openconnect-gnome
+Once installed open Settings and go to Network, press + right of the VPN section.
+{{:auth:howto:linux:network_vpn.png?400|}}
+Select **Cisco AnyConnect Compatible VPN (openconnect)** and fill out as shown below:
+{{:auth:howto:linux:add_vpn_openconnect.png?400|}}
+{{:auth:howto:linux:details_vpn.png?300|Details}} {{:auth:howto:linux:identity_vpn.png?300|Identity}}
+{{:auth:howto:linux:ipv4_vpn.png?300|IPv4}} {{:auth:howto:linux:ipv6_vpn.png?300|IPv6}}
+**Details**
+  - Make available to other users: tick if you want to allow other users on your system to use the VPN
+**Identity**
+  - Name: VPN work (use a descriptive name)
+  - VPN Protocol: Cisco AnyConnect
+  - Gateway: vpn.scientificnet.org
+  - CA Certificate: download from {{ :auth:howto:linux:vpn-scientificnet-org.pem |here}}, not really necessary!
+The rest can be left as it is.
+**IPv4/IPv6**
+  - IPv4 Method: Automatic (DHCP)
+  - DNS: ON
+  - Routes: ON
+Press <color #22b14c>Apply</color>
+Now you can enable the VPN connection!
+Move the slider from OFF to ON, a small window should open,
+{{:auth:howto:linux:enable_vpn.png?400|Enable VPN}}
+make sure that for VPN Host you select: **vpn.scientificnet.org**
+Enter your unibz Username, without @unibz.it and your unibz Password.
+{{:auth:howto:linux:connect_vpn.png?400|Connect VPN}}
+Press **Login**
+If all goes well the slider should remain in ON position, if not check the Log.
+To verify launch this command in a terminal:
+  ifconfig
+You should get a new interface --> vpn0: with an IP Address: 172.xxx.xxx.xxx
+===== Instructions for Linux vpnc Client =====
 . Install vpnc