auth:howto:linux:vpnclient
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
auth:howto:linux:vpnclient [2020/04/21 11:29] – kohofer | auth:howto:linux:vpnclient [2020/04/21 16:56] – kohofer | ||
---|---|---|---|
Line 68: | Line 68: | ||
- Enter Password if not already entered above | - Enter Password if not already entered above | ||
- | ===== Instructions for Linux using Openconnect | + | ===== Instructions for Linux using openconnect |
+ | Run this command to install openconnect client and OpenConnect plugin GNOME GUI | ||
+ | sudo apt install openconnect network-manager-openconnect network-manager-openconnect-gnome | ||
+ | |||
+ | Once installed open Settings and go to Network, press + right of the VPN section. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Select **Cisco AnyConnect Compatible VPN (openconnect)** and fill out as shown below: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **Details** | ||
+ | - Make available to other users: tick if you want to allow other users on your system to use the VPN | ||
+ | |||
+ | **Identity** | ||
+ | - Name: VPN work (use a descriptive name) | ||
+ | - VPN Protocol: Cisco AnyConnect | ||
+ | - Gateway: vpn.scientificnet.org | ||
+ | - CA Certificate: | ||
+ | |||
+ | The rest can be left as it is. | ||
+ | |||
+ | **IPv4/ | ||
+ | - IPv4 Method: Automatic (DHCP) | ||
+ | - DNS: ON | ||
+ | - Routes: ON | ||
+ | |||
+ | Press <color # | ||
+ | |||
+ | Now you can enable the VPN connection! | ||
+ | |||
+ | Move the slider from OFF to ON, a small window should open, | ||
+ | |||
+ | {{: | ||
+ | |||
+ | make sure that for VPN Host you select: **vpn.scientificnet.org** | ||
+ | |||
+ | Enter your unibz Username, without @unibz.it and your unibz Password. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Press **Login** | ||
+ | |||
+ | If all goes well the slider should remain in ON position, if not check the Log. | ||
+ | To verify launch this command in a terminal: | ||
+ | |||
+ | ifconfig | ||
+ | |||
+ | You should get a new interface --> vpn0: with an IP Address: 172.xxx.xxx.xxx | ||
===== Instructions for Linux vpnc Client ===== | ===== Instructions for Linux vpnc Client ===== |
/data/www/wiki.inf.unibz.it/data/pages/auth/howto/linux/vpnclient.txt · Last modified: 2022/06/20 11:40 by kohofer