Differences

This shows you the differences between two versions of the page.

--- auth:howto:linux:vpnclient [2020/04/21 14:00] – [Installation] kohofer
+++ auth:howto:linux:vpnclient [2020/04/21 14:16] – [Installation] kohofer
@@ Line 95: / Line 95: @@
   - VPN Protocol: Cisco AnyConnect
   - Gateway: vpn.scientificnet.org
-  - CA Certificate: download from here, not really necessary!
+  - CA Certificate: download from {{ :auth:howto:linux:vpn-scientificnet-org.pem |here}}, not really necessary!
 The rest can be left as it is.
@@ Line 104: / Line 104: @@
   - Routes: ON
+Press <color #22b14c>Apply</color>
+Now you can enable the VPN connection!
+Move the slider from OFF to ON, a small window should open,
+{{:auth:howto:linux:enable_vpn.png?400|Enable VPN}}
+make sure that for VPN Host you select: **vpn.scientificnet.org**
+Enter your unibz Username, without @unibz.it and your unibz Password.
+{{:auth:howto:linux:connect_vpn.png?400|Connect VPN}}
+Press **Login**
+If all goes well the slider should remain in ON position, if not check the Log.
+To verify launch this command in a terminal:
+  ifconfig
+You should get a new interface --> vpn0: with an IP Address: 172.xxx.xxx.xxx
 ===== Instructions for Linux vpnc Client =====